#12
Nautor comment
The #12 must be machined on place.
Bolt dimensions
- D2 — Total bolt height
- 75.82 mm
- D1 — Lead to thread
- 26 mm
- H1 — Hull hole depth
- 37.94 mm
- H2 — Keelson to plate
- 23.49 mm
- Plate thickness (calc.)
- 14.45 mm
- Keel width at station
- 13.38 in
D2 is the bolt's total height, from the head/tip down to the top of the lead. D1 is the height from the lead up to where the threads start. H1 is how deep the hole in the hull is where the bolt sits. H2 is the thickness from the bottom of the keelson to the bottom of the internal plate. Plate thickness is calculated as H1 minus H2. Keel width is measured across the bolt centers at this bolt's station.
Backing plate
Two-hole plate, shared with #13- Height (fore/aft)
- 80 mm
- Width (athwartships)
- 219.2 mm (8.63 in)
- Depth (thickness)
- 8 mm
- Hole diameter
- 36 mm
- Condition
- Flat
Proof Test / Fixture
Starting proof-test stack — a calculated starting point, not an approved dimension. H1 is remeasured in the field before every test.
- Baseline H1
- 37.94 mm
- Calculated starting height
- 37.88 mm
- Delta
- -0.06 mm
- Latest result
- PASS
Disposition: Retain existing bolt / thread
Proof test record Attempt 1 · PASS · Retain existing bolt / thread
Test Attempts
Attempt 1 PASS
Pre-Test Inspection
Acceptable
Damaged
Yes
Yes
—
—
Fixture Actually Used
—
37.94
0
0
0
—
Proof Test
Lubricated
Tap Magic
—
254
No
—
254
Pass
—
—
Disposition
Retain
—
—
Machining / Re-Threading
—
—
—
—
—
—
—
—
—
—
—
—
Extension / Prosthesis
—
—
—
—
—
—
—
—
—
—
—
Final Installation
—
—
—
—
—
—
—
—
—
—
—
—
Sign-Off / Traceability
—
—
—
—