#9 — proposed extension v2 (Nov 12, 2026), profile cutaway

To scale, section through the bolt centreline. Heights in mm above the lead keel baseline. Fiberglass + 8 mm backing plate taken from this bolt's H1. The air gap between the keel and hull faces isn't measurable here (about 0–7 mm); it's drawn at 0, which puts the plate lowest. The design clears the plate either way, and the stud gives full nut engagement up to a 7 mm gap at #8.

Before — #9 as it stands

33.5 (H1) 76.1 tip (D2) 23 in nut #9: Full nut engagement, 19.6 proud M30 nut (23) 8 mm backing plate Fiberglass (25.5) Lead keel (baseline 0)

After — with extension · v2 (Nov 12, 2026)

M30 extension v2 (Nov 12, 2026) 31.5 excavation 23.5 shoulder 54.6 stud 33.5 (H1) 78.1 tip 109.6 total 35mm (10 threads) 5 2 23 Ø50 body 63 plate 75.7 excavation (63 + ½″) Full nut engagement, 21.6 proud Fiberglass hole enlarged to Ø52 up to ~24.5 only — stays clear of the backing plate Tack weld (316 stainless filler) 63×63×6 plate, Ø50.3 hole, top flush with keel Existing M30 bolt, cut to 40 above excavation floor Extension: Ø50 body, M30 female thread Lead keel (baseline 0)

Extension: XM-19 HS, ASTM A479 — MTR required; weld plate 316 stainless, tack welded with 316 stainless filler. M30 nut, 23 mm, seated on the backing plate with no washer (drawn across corners). The original bolt's thread starts at D1. Excavation 75.7 mm square (63 + ½″, the original plate's pocket widened chiselling it out), round the 63 mm plate. Assumed: the fiberglass hole is enlarged to Ø52 (about 1 mm clearance on the Ø50 body).